2019-04-29

How to check if an AS15 chip is working ok

An AS15 is nothing but a 14 + 1 channel buffer. 15 reference voltages at the inputs are buffered for higher currents on the outputs. A resistor ladder is connected to a reference voltage source and the AS15 picks up each of the ladder voltages and presents it at the outputs.

The typical image symptoms of a defect AS15 chip on TCON boards are:

  • solarization - colors, especially darker ones are pink or green, for example
  • faded colors

Many TVs with AUO panels built around 2009 have this defect.

First quick test: does it get hot? It must not. According to the datasheet, its idle current is 10-20 mA. That's not enough to heat up a chip. The last TCON I fixed reduced its total idle current by 150mA with a new chip.

Besides apparent overheating, there is a technique to verify the chip's performance.
Locate testpoints named VGA or VGMA, numbered 1 to 14 or up to 22. Measure those against ground. They must produce a consecutive sequence of decreasing voltage of around 15 down to 0. If there are "holes" or big jumps in between, the chip is broken.

However, the exact values vary between panels. There is no rule.

Also, locate the VGMAREF test point of the reference voltage. A typical voltage level there is 15.6V. I had a couple of defect TCONs where VGMA0 measured slightly higher than 15.6V. Apart from that everything looked ok. This is not possible in a working configuration! The reason is the AS15 leaking voltage to the inputs from its power supply rail.

Note that some TCONs have 0V holes in the testpoint sequence because they only produce 14 or 18 voltages for 22 channels. Those TCONs have solder pads for up to two 4xOPAs, which are the buffers for voltages #15 to #22. Those are not always populated. The panels are wired to pick the active outputs accordingly. You must trace the origin of the testpoint voltages whether they lead to the AS15 or to the missing OPAs.

2 comments:

  1. Thank you, Alpengeist, for sharing that information. I replaced an AS15 which solved the white washed picture but the picture still flickered a bit / getting brighter or darker in random succession. After some testing I was not sure what caused that problem but the picture went white again.... at least I know now how to check, if it actually IS the AS15 causing trouble. I ordered some new AS15 to see what will bring ;-)

    ReplyDelete
  2. Well, I think the replacement AS15 did not do its job or got damaged during the process. It is really easy to measure. Thus, the diagnosis should be straightforward.

    ReplyDelete

Note: Only a member of this blog may post a comment.